Pulsar
PULSAR thermal targets for zeroing
PULSAR thermal targets for zeroing
Tienda Almansa
Pol. Ind. III Fase - C/ Ronda Sur, 7
02640 Almansa
Albacete
Spain
* DISPONIBILIDAD Y ENVÍO
El plazo de expedición depende de la disponibilidad del producto y de la variante seleccionada en nuestra tienda física.
Si está disponible en tienda: el plazo previsto de expedición es de menos de 72 horas.
Si no está disponible en tienda: se solicitará al proveedor y el plazo podrá ser superior a 72 horas. La disponibilidad y el plazo de suministro dependen del proveedor.
Los gastos de envío pueden variar según el producto y su procedencia. El importe aplicable se indicará antes de finalizar la compra.
* Al continuar con la compra, aceptas las condiciones de disponibilidad y los plazos de entrega indicados.
Pulsar Optik heated targets for simple and precise zeroing of a thermal imaging riflescope.
How to use:
Follow 10 steps for successful use of heated targets:
1. The heat pack is air-activated; do not open the pad package until ready to use.
2. Open the packaging and take out the heat pad.
3. Attention! Do not cut or damage the heat pad while taking it out.
4. Remove the paper strip from the back of the heat pad to expose the adhesive surface.
5. Stick the heat pad with the adhesive side to the center of the circle-marked paper target.
6. Attention! It is not necessary to shake the heat pad; it will heat up on its own in 3-5 minutes.
7. Attach the paper target to the desired location.
8. Aim at the heat pad with a thermal imaging riflescope mounted on the firearm and optimize the thermal view so that the heat pad is clearly visible.
9. Perform the zeroing procedure as described in your thermal imaging device's user manual.
10. With the help of the round shape and small diameter of the pad, deviations in the point of impact can be eliminated with just a few shots.
Specifications of the activated heat pack:
Quantity in the box:
- 10 pieces paper target size: 30 x 30 cm
- 10 pieces activated carbon heat pads with adhesive side: 40 mm (hot surface)
Duration the pad remains hot: 10-20 min, on cold surfaces (depends on weather conditions)
Ingredients: iron powder, activated carbon, vermiculite, salt, resin, water.